Mitsubishi NZ2GFCF-D62PD2 User Manual page 109

(5) Output setting on Coincidence output 1 to 4 terminals (EQU1 to EQU4)
To output signals from Coincidence output 1 to 4 terminals (EQU1 to EQU4) to outside, enable output by turning
on CH Coincidence output enable command (RY20, RY38).
Doing so enables all coincidence outputs assigned to the target channel in "Coincidence output 1 to 4 channel
assignment setting".
Comparison
Comparison setting item
condition
Point setting (Coincidence output 1 to
Coincidence
4) (RWw0 to RWw1, RWw4 to RWw5,
output
RWw8 to RWw9, RWwC to RWwD)
• Upper limit value setting
(Coincidence output 1 to 4) (RWw2
to RWw3, RWw6 to RWw7, RWwA
Within-range
to RWwB, RWwE to RWwF)
output or out-of-
• Lower limit value setting
range output
(Coincidence output 1 to 4) (RWw0
to RWw1, RWw4 to RWw5, RWw8
to RWw9, RWwC to RWwD)
Turning off then on Initial data processing completion flag (RY8) when the comparison condition is coincidence output or
when the comparison setting item for within-range output (Point setting (Coincidence output 1)/Lower limit value setting
(Coincidence output 1) (RWw0 to RWw1) to Upper limit value setting (Coincidence output 4) (RWwE to RWwF)) is 0 (default)
turns on Coincidence output 1 to 4 (RX10 to RX13) because CH Present value (RWr10 to RWr11, RWr28 to RWr29) of
when Initial data processing request flag (RX8) is turned off is 0 (default). To turn off Coincidence output 1 to 4 (RX10 to
RX13), set the comparison setting item to other than 0 or to a range that does not include 0 before turning off then on Initial
data processing completion flag (RY8).
Setting details
Set the point to be compared with the present
value.
Set the upper and lower limit values for the area
to be compared with the present value.
When the upper limit value is less than the
lower limit value, Upper limit value setting error
(Coincidence output 1 to 4) (error code: 311
to 314 ) occurs.
H
CHAPTER 8 FUNCTIONS
Reference
Page 261, Appendix 2 (7),
Page 262, Appendix 2 (8)
Page 261, Appendix 2 (7),
Page 262, Appendix 2 (8)
H
107
8