List Of Remote Register - Mitsubishi NZ2GFCF-D62PD2 User Manual

3.6

List of Remote Register

This section lists remote registers for a master/local module.
In the example of the remote register assignment described in this section, the remote registers of the main module
are assigned to the remote registers of RWr0 to RWr3F and RWw0 to RWw3F.
The remote registers are assigned per station regardless of the main module or the extension module.
Remote register (RWr) is the information input from the high-speed counter module to the master/local module.
Remote register (RWw) is the information output from the master/local module to the high-speed counter module.
For details on the remote register, refer to the following.
Page 255, Appendix 2
Remote register (RWr) signal direction: High-speed
counter module → Master/local module
Device
number
RWr0 Counter value greater/smaller signal
RWr1 EQU1 to EQU4 terminal status
RWr2 Cam switch output signal
RWr3 Cam switch output terminal status
RWr4 Use prohibited
RWr5 Use prohibited
RWr6 Use prohibited
RWr7 Use prohibited
RWr8 Use prohibited
RWr9 Use prohibited
RWrA Use prohibited
RWrB Use prohibited
RWrC Use prohibited
RWrD Use prohibited
RWrE Use prohibited
RWrF Use prohibited
RWr10
CH1 Present value
RWr11
RWr12
CH1 Latch count value/Sampling count value/Periodic
pulse count, difference value
RWr13
RWr14
CH1 Periodic pulse count, present value
RWr15
RWr16
CH1 Periodic pulse count value update check
RWr17
RWr18
CH1 Latch count value (Latch counter input terminal)
RWr19
RWr1A
CH1 Measured frequency value/Measured rotation
speed value
RWr1B
RWr1C
CH1 Measured pulse value (Function input terminal)
RWr1D
Description
Remote register (RWw) signal direction: Master/local
module → High-speed counter module
Device
number
RWw0
Point setting (Coincidence output 1)/
Lower limit value setting (Coincidence output 1)
RWw1
RWw2
Upper limit value setting (Coincidence output 1)
RWw3
RWw4
Point setting (Coincidence output 2)/
Lower limit value setting (Coincidence output 2)
RWw5
RWw6
Upper limit value setting (Coincidence output 2)
RWw7
RWw8
Point setting (Coincidence output 3)/
Lower limit value setting (Coincidence output 3)
RWw9
RWwA
Upper limit value setting (Coincidence output 3)
RWwB
RWwC
Point setting (Coincidence output 4)/
Lower limit value setting (Coincidence output 4)
RWwD
RWwE
Upper limit value setting (Coincidence output 4)
RWwF
RWw10
CH1 Ring counter lower limit value
RWw11
RWw12
CH1 Ring counter upper limit value
RWw13
RWw14
CH1 Preset value setting
RWw15
CH1 Time unit setting
RWw16
(Sampling counter/Periodic pulse counter)
CH1 Cycle setting
RWw17
(Sampling counter/Periodic pulse counter)
CH1 Time unit setting (Frequency
RWw18
measurement/Rotation speed measurement)
CH1 Moving average count (Frequency
RWw19
measurement/Rotation speed measurement)
RWw1A
CH1 Number of pulses per rotation
RWw1B
RWw1C Use prohibited
RWw1D CH1 PWM output assignment setting
CHAPTER 3 SPECIFICATIONS
Description
39
3