Mitsubishi NZ2GFCF-D62PD2 User Manual page 24

No. Name
Station number setting
1)
switch
PW LED (green)
ON
OFF
RUN LED (green)
ON
OFF
MODE LED (green)
ON
Flashing
OFF
D LINK LED (green)
ON
Flashing
OFF
ERR. LED (red)
ON
2)
Flashing
OFF
CH1φA/φB/φZ LED
CH2φA/φB/φZ LED
(green)
ON
OFF
CH1FNC/LAT LED
CH2FNC/LAT LED
(green)
ON
OFF
EQU1 to EQU4 LED
(green)
ON
OFF
22
A rotary switch for the following setting and test
• Station Number Setting (
• Unit Test ( Page 227, Section 11.4)
When operating the station number setting switch, use a slotted screwdriver with 3.5mm or less width
of the tip.
Indicates the power supply status of the module.
Power supply ON
Power supply OFF
Indicates the operating status of the module.
Operating normally
When a major error occurs
Indicates the mode status of the module.
In online mode
In unit test mode
At the unit test completion
Indicates the data communication status between the module and the master module.
Data link in operation (cyclic transmission in progress)
Data link in operation (cyclic transmission stopped)
Data link not performed (disconnected)
Indicates the error status of the module.
A moderate error or major error has occurred.
A minor error (warning) has occurred.
Operating normally
Indicates the input status of the pulse input terminals in phase A, B, and Z.
At voltage application
At no voltage application
Indicates the input status of the function/latch counter input terminal.
At voltage application
At no voltage application
Indicates the output status of the coincidence output 1 to 4 terminals (EQU1 to EQU4).
Signal output ON
Signal output OFF
Description
Page 55, Section 6.1)