Mitsubishi NZ2GFCF-D62PD2 User Manual page 195

(8) Program example under the normal mode (when the coincidence output is set
with the comparison output function)
(a) Common program
*1 Add the following MCR instruction at the end of the program.
If the master station does not receive a response for several link scans from the high-speed counter module, the high-speed
counter module is determined as a cyclic transmission faulty station and the corresponding bit of the data link status (each
station) (SW00B0 to SW00B7) turns on.
(b) Initial setting program
*1 Set only when using the ring counter function.
*2 Set only when using the sampling counter function or periodic pulse counter function.
CHAPTER 9 PROGRAMMING
Check the data link status (station No.1)
*1
(NZ2GFCF-D62PD2).
Start remote register initial settings.
Point setting (Coincidence output 1)
Lower limit value setting (Coincidence output 2)
Upper limit value setting (Coincidence output 2)
*1
CH1 Ring counter lower limit value setting
CH1 Ring counter upper limit value setting
CH1 Preset value setting
*2
CH1 Time unit setting
(Sampling counter/Periodic pulse counter)
CH1 Cycle setting
(Sampling counter/Periodic pulse counter)
Set values to the remote register.
Turn on Initial data processing completion flag.
Turn off Initial data processing completion flag.
9
193