Mitsubishi NZ2GFCF-D62PD2 User Manual page 243

Remote input
Signal name
(RX) No.
RX21 CH1
Preset/replace
completion
RX39 CH2
RX23 CH1
External
preset/replace
(Z Phase)
request
detection
RX3B CH2
• This signal turns on when the preset is completed by turning on CH Preset/replace
command (RY21, RY39).
• This signal turns off when CH Preset/replace command (RY21, RY39) is turned off.
Controlled by the high-speed counter module
Controlled by the program
CH Preset value setting
(RWw14 to RWw15, RWw2C to RWw2D)
CH Preset/replace command
(RY21, RY39)
CH Preset/replace completion
(RX21, RX39)
CH Present value
(RWr10 to RWr11, RWr28 to RWr29)
*1
• Up to ΔT
delay occurs until this signal turns on after the preset is completed.
1
*1 For ΔT , refer to Page 283, Appendix 4.
1
• This signal turns on when a count value is replaced with the preset value by CH Phase Z
input terminal (Z1, Z2). Note that this signal does not turn on when Z phase (Preset) trigger
setting (address: 0125 .b0 to b1, 0145
H
0145 ) is set to During ON (11).
H
• This signal turns off when CH External preset/replace (Z Phase) request detection reset
command (RY23, RY3B) is turned on.
• The value is not replaced while this signal is on.
• Note that this signal does not turn on when External preset/replace (Z Phase) request
detection setting (address: 0125
0145 ) is set to Not ON at detection (1). This signal turns on only when External
H
preset/replace (Z Phase) request detection setting (address: 0125
ON at detection (0).
• The following figure shows the case when Z phase (Preset) trigger setting (address:
0125 .b0 to b1, 0145 .b0 to b1) in CH Phase Z setting (address: 0125
H H
Rising (00).
Controlled by the high-speed counter module
Controlled by the program
CH Preset value setting
(RWw14 to RWw15, RWw2C to RWw2D)
CH Phase Z input terminal
(Z1, Z2)
CH External preset/replace (Z Phase)
request detection
(RX23, RX3B)
CH External preset/replace (Z Phase)
request detection reset command
(RY23, RY3B)
CH Present value
(RWr10 to RWr11, RWr28 to RWr29)
*1
• Up to ΔT
delay occurs until this signal turns on after the preset is completed.
1
*1 For ΔT , refer to Page 283, Appendix 4.
1
Description
100
ON
OFF
ON
OFF
0
.b0 to b1) in CH Phase Z setting (address: 0125
H
.b4, 0145 .b4) in CH Phase Z setting (address: 0125
H H
100
ON
OFF
ON
OFF
OFF
0
APPENDICES
100
,
H
,
H
.b4, 0145 .b4) is set to
H H
, 0145 ) is set to
H H
ON
t
100
t T
1
241
A