No.
1)
Counting starts by turning on CH Count enable command (RY24, RY3C).
Counting stops by turning on CH Selected counter function start command (RY25, RY3D).
2)
Also, CH Counter function detection (RX25, RX3D) turns on by turning on CH Selected counter function start command (RY25,
RY3D).
Counting resumes by turning off CH Selected counter function start command (RY25, RY3D).
3)
Also, CH Counter function detection (RX25, RX3D) turns off by turning off CH Selected counter function start command (RY25,
RY3D).
4)
Counting stops by turning on CH Function input terminal (FUNC1, FUNC2).
5)
Counting resumes by turning off CH Function input terminal (FUNC1, FUNC2).
6)
Counting stops by turning off CH Count enable command (RY24, RY3C).
Counting stops regardless of CH Selected counter function start command (RY25, RY3D) since CH Count enable command
7)
(RY24, RY3C) is off.
Counting remains stopped even if CH Count enable command (RY24, RY3C) is turned on since CH Selected counter function
8)
start command (RY25, RY3D) is on.
9)
Counting resumes by turning off CH Selected counter function start command (RY25, RY3D).
132
Description