Mitsubishi NZ2GFCF-D62PD2 User Manual page 268

(14)Remote registers (RWw1D to RWw21, RWw35 to RWw39)
Address
(RWw)
Item
CH1 CH2
PWM output
1D 35
assignment setting
1E 36 ON width setting
1F 37 (PWM output)
20 38 Cycle setting (PWM
21 39 output)
266
• Select an output target from Coincidence output 1 to 4 to output the PWM
waveform using the PWM output function.
• This setting applies only to coincidence outputs where the corresponding
channels are assigned using Coincidence output channel assignment setting
(address: 0101 ). Two or more points can be set.
H
• The following shows the setting range.
b15 b14 b13 b12 b11 b10
0 0 0 0 0 0
0 (fixed)
• The reflection timing of the setting value
When CH Cam switch execute command/PWM output start command
(RY26, RY3E) is turned off then on
• Set the ON width of the PWM waveform for the PWM output function.
• The following shows the setting range.
0, and 10 to 10000000 (increments of 0.1µs) (Set a value that is equal to or
smaller than the value in the cycle setting (PWM output).)
• The reflection timing of the setting value
1) When CH Cam switch execute command/PWM output start command
(RY26, RY3E) is turned off then on
2) When CH ON width setting change request (PWM output) (RY35, RY4D)
is turned off then on
• Set the cycle of the PWM waveform for the PWM output function.
• The following shows the setting range.
50 to 10000000 (increments of 0.1µs)
• The reflection timing of the setting value
When CH Cam switch execute command/PWM output start command
(RY26, RY3E) is turned off then on
Description
b9 b8 b7 b6 b5 b4 b3
Coinci-
0 0 0 0 0 0
dence
output 4
Default
b2 b1 b0 0000
H
Coinci- Coinci- Coinci-
dence dence dence
output 3 output 2 output 1
0: No Assignment
1: Assignment
0
0