Mitsubishi NZ2GFCF-D62PD2 User Manual page 145

(2) Operation example of the count disable/preset/replace function
The following figure shows an operation example of stopping counting while CH Function input terminal
(FUNC1, FUNC2) is on and storing the preset value (0 or 100) in CH Present value (RWr10 to RWr11, RWr28
to RWr29) at the falling edge of CH Function input terminal (FUNC1, FUNC2).
Controlled by the high-speed counter module
Controlled by the program
CH Count enable command
(RY24, RY3C)
CH Preset value setting
(RWw14 to RWw15,
RWw2C to RWw2D)
CH Function input terminal
(FUNC1, FUNC2)
CH Present value
(RWr10 to RWr11, RWr28 to RWr29)
For ΔT
*1 , refer to Page 283, Appendix 4.
1
No.
1) Counting starts by turning on CH Count enable command (RY24, RY3C).
2) Counting stops at the rising edge of CH Function input terminal (FUNC1, FUNC2).
The value in CH Preset value setting (RWw14 to RWw15, RWw2C to RWw2D) is stored in CH Present value (RWr10 to RWr11,
3)
RWr28 to RWr29) at the falling edge of CH Function input terminal (FUNC1, FUNC2), and the counting resumes.
4) Set any values to CH Preset value setting (RWw14 to RWw15, RWw2C to RWw2D).
5) Counting stops by turning off CH Count enable command (RY24, RY3C).
Counting stops regardless of CH Function input terminal (FUNC1, FUNC2) since CH Count enable command (RY24, RY3C) is
6)
off.
Counting remains stopped even if CH Count enable command (RY24, RY3C) is turned on since CH Function input terminal
7)
(FUNC1, FUNC2) is on.
The value in CH Preset value setting (RWw14 to RWw15, RWw2C to RWw2D) is stored in CH Present value (RWr10 to RWr11,
8)
RWr28 to RWr29) at the falling edge of CH Function input terminal (FUNC1, FUNC2), and the counting resumes.
1) ON
OFF
0
2)
ON
OFF
100
0
Count stop Count stop
Description
5)
4)
100
T or more
1
3)
Pulses actually input
CH Present value
(RWr10 to RWr11, RWr28 to RWr29)
stored in a remote register
CHAPTER 8 FUNCTIONS
7)
*1
6) 8)
Count stop
143
8