Mitsubishi NZ2GFCF-D62PD2 User Manual page 271

(5) Module-based parameter data (address: 0104
Address
Name
CH1 CH2
Cam switch output
0104
unit assignment
H
setting
Cam switch output
0105
channel assignment
H
setting
(6) Module-based parameter data (address: 0120
Address
Name
CH1 CH2
Operation mode
0120 0140
H H
setting
Count source
0121 0141
H H
selection
• Set an extension output module to be used with the cam switch function.
• The following shows the setting range.
0: No Assignment
1: Stage 1
• The reflection timing of the setting value
When Initial data setting request flag (RY9) is turned off then on
• Set channels to be compared for the outputs of the cam switch function.
• The following shows the setting range.
b15 b14 b13 b12 b11 b10 b9
16) 15) 14) 13) 12) 11) 10)
1) Cam switch output 1 channel assignment setting
2) Cam switch output 2 channel assignment setting
: :
15) Cam switch output 15 channel assignment setting
16) Cam switch output 16 channel assignment setting
• The reflection timing of the setting value
When Initial data setting request flag (RY9) is turned off then on
• Set the operation mode for channels.
• The following shows the setting range.
0: Normal Mode
1: Frequency Measurement Mode
2: Rotation Speed Measurement Mode
3: Pulse Measurement Mode
4: PWM Output Mode
• The reflection timing of the setting value
When Initial data setting request flag (RY9) is turned off then on
• Set the count source.
• The following shows the setting range.
0: A Phase/B Phase
1: Coincidence Output 1
2: Coincidence Output 2
• When CH Count source selection (address: 0121
Coincidence Output 1 (1) or Coincidence Output 2 (2), pulses are counted
up at the rising edge of the following signals.
Normal mode: Coincidence output 1 to 2 (RX10 to RX11)
PWM output mode: Coincidence output 1 to 2 terminals (EQU1 to EQU2)
• The reflection timing of the setting value
When Initial data setting request flag (RY9) is turned off then on
to 0105 )
H H
Description
b8 b7 b6 b5 b4 b3
9) 8) 7) 6) 5) 4)
0: CH1
1: CH2
to 0121 , 0140
H H
Description
, 0141 ) is set to
H H
APPENDICES
Default
0
b2 b1 b0
3) 2) 1)
0000
H
to 0141 )
H H
Default
0
0
269
A