Mitsubishi NZ2GFCF-D62PD2 User Manual page 273

(8) Module-based parameter data (address: 0124
Address
Name
CH1 CH2
0124 0144
Counter format
H H
0125 0145
Phase Z setting
H H
• Set the counter format.
• The following shows the setting range.
0: Linear Counter
1: Ring Counter
• The reflection timing of the setting value
When Initial data setting request flag (RY9) is turned off then on
• Set the trigger condition to replace a count value with the preset value by
CH Phase Z input terminal (Z1, Z2).
• Set whether to turn on CH External preset/replace (Z Phase) request
detection (RX23, RX3B) or not when a count value is replaced with the
preset value by CH Phase Z input terminal (Z1, Z2).
• While CH Z phase (Preset) trigger setting (address: 0125
0145 .b0 to b1) is on, CH External preset/replace (Z Phase) request
H
detection setting (address: 0125
External preset/replace (Z Phase) request detection (RX23, RX3B) is
always off.
• The following shows the setting range.
b15 b14 b13 b12 b11 b10 b9
0 0 0 0 0 0 0
0 (fixed)
1) Z phase (Preset) trigger setting
00: Rising
01: Falling
10: Rising + Falling
11: During ON
2) External preset/replace (Z Phase) request detection setting
0: ON at detection
1: Not ON at detection
• The reflection timing of the setting value
When Initial data setting request flag (RY9) is turned off then on
to 0125 , 0144
H H
Description
.b0 to b1,
H
.b4, 0145 .b4) is disabled and CH
H H
b8 b7 b6 b5 b4 b3
0 0 0 0 2) 0
0 (fixed)
APPENDICES
to 0145 )
H H
Default
0
b2 b1 b0
0000
H
0 1)
271
A