Mitsubishi NZ2GFCF-D62PD2 User Manual page 128

● While CH External preset/replace (Z Phase) request detection (RX23, RX3B) is on, the value cannot be replaced by
any methods. Replace the value after turning off CH External preset/replace (Z Phase) request detection (RX23,
RX3B) by turning on CH External preset/replace (Z Phase) request detection reset command (RY23, RY3B).
● Have a ΔT
CH Phase Z input terminal (Z1, Z2) is turned on because there are maximum of ΔT
value setting (RWw14 to RWw15, RWw2C to RWw2D) is reflected. An interval is not necessary when the preset/replace
function is performed by the preset/replace command since there is a delay of when the preset/replace command is
*1
used.
● When the preset/replace function is performed by CH Phase Z input terminal (Z1, Z2), the operation response time
follows CH Z phase input response time setting (address: 0129
(RWr10 to RWr11, RWr28 to RWr29) is updated synchronizing with the internal control cycle, a maximum of delay time
shown below occurs until the preset value is stored.
• ΔT
*1 For ΔT , refer to Page 283, Appendix 4.
1
126
or longer interval after changing CH Preset value setting (RWw14 to RWw15, RWw2C to RWw2D) until
1
*1
+ Setting time of CH Z phase input response time setting (address: 0129
1
delay until change in CH Preset
1
.b0 to b1, 0149 .b0 to b1). Since CH Present value
H H
.b0 to b1, 0149
H
.b0 to b1)
H