Mitsubishi NZ2GFCF-D62PD2 User Manual page 253

Remote
output Signal name
(RY) No.
RY21 CH1
Preset/replace
command
RY39 CH2
RY22 CH1
Count down
command
RY3A CH2
External
RY23 CH1
preset/replace
(Z Phase)
request
RY3B CH2
detection reset
command
RY24 CH1
Count enable
command
RY3C CH2
Operation
timing
• Turn on this signal to replace a count value with the preset value.
• The value cannot be replaced by turning on this signal while CH External
preset/replace (Z Phase) request detection (RX23, RX3B) is on. Turn off CH
External preset/replace (Z Phase) request detection (RX23, RX3B) by using CH
External preset/replace (Z Phase) request detection reset command (RY23,
RY3B).
(For the overview of the operation, refer to Page 236, Appendix 1.1.)
• Turn on this signal to count down pulses.
• This signal is valid when 1-Phase Multiple of 1 (0) or 1-Phase Multiple of 2 (1) is
selected for CH Pulse input mode (address: 0122
• Inputting pulse in phase B can also start counting down pulses.
• The following figure shows the overview of the operation (when 1-Phase Multiple
of 1 (0) is selected for CH1 Pulse input mode (address: 0122
*1
• Up to ΔT
is taken until this signal has been turned on.
1
*1
CH1 Count
down command
CH1 Present value
(RWr10 to RWr11)
• Turn on this signal to turn off CH External preset/replace (Z Phase) request
detection (RX23, RX3B).
• A count value cannot be replaced with the preset value while CH External
preset/replace (Z Phase) request detection (RX23, RX3B) is on.
• For the overview of the operation, refer to Page 236, Appendix 1.1.
• Turn on this signal to count pulses.
• The following figure shows the overview of the operation (when 1-Phase Multiple
of 1 (0) is selected for CH1 Pulse input mode (address: 0122
enable command
CH1 Present value
(RWr10 to RWr11)
Description
For ΔT
, refer to Page 283, Appendix 4.
1
ON
A
OFF
ON
B
OFF
OFF
(RY22)
99 100 101
ON
OFF
A
ON
OFF
B
CH1 Count
OFF
(RY24)
0
APPENDICES
, 0142 ).
H H
)).
H
ON
100 99 98
)).
H
ON
1 2 3 4
251
A