Mitsubishi NZ2GFCF-D62PD2 User Manual page 267

(12)Remote registers (RWw18 to RWw19, RWw30 to RWw31)
Address
(RWw)
Item
CH1 CH2
Time unit setting
(Frequency
measurement)
18 30
Time unit setting
(Rotation speed
measurement)
Moving average count
(Frequency
measurement)
19 31
Moving average count
(Rotation speed
measurement)
(13)Remote registers (RWw1A to RWw1B, RWw32 to RWw33)
Address
(RWw)
Item
CH1 CH2
1A 32 Number of pulses per
1B 33 rotation
• Set a unit of time of frequency measurement for frequency measurement
function.
• The following shows the setting range.
0: 0.01s
1: 0.1s
2: 1s
• The reflection timing of the setting value
When CH Count enable command (RY24, RY3C) is turned off then on
• Set a unit of time of rotation speed measurement for the rotation speed
measurement function.
• The following shows the setting range.
0: 0.01s
1: 0.1s
2: 1s
• The reflection timing of the setting value
When CH Count enable command (RY24, RY3C) is turned off then on
• Set the number of moving average count of frequency measurement for the
frequency measurement function.
• The following shows the setting range.
1 to 100 (However, when 1 is set, the operation is performed with the moving
average count regarded as not being done.)
• The reflection timing of the setting value
When CH Count enable command (RY24, RY3C) is turned off then on
• Set the number of moving average count of rotation speed measurement for
the rotation speed measurement function.
• The following shows the setting range.
1 to 100 (However, when 1 is set, the operation is performed with the moving
average count regarded as not being done.)
• The reflection timing of the setting value
When CH Count enable command (RY24, RY3C) is turned off then on
• Set the number of pulses per rotation for the pulse measurement function.
• The following shows the setting range.
1 to 8000000
• The reflection timing of the setting value
When CH Count enable command (RY24, RY3C) is turned off then on
Description
Description
APPENDICES
Default
A
0
0
Default
0
265