8.4
Preset/replace Function
The preset/replace function replaces the count value with any value preset by the user. This value is called a preset
value.
This function can be used to start counting pulses from the preset value.
Perform this function by one of the following methods. This section describes No.1 and 2.
No.
1
Performing the preset/replace function by a program
2
Performing the preset/replace function by CH Phase Z input terminal (Z1, Z2)
3
Performing the preset/replace function by the preset/replace (at coincidence output) function
4
Performing the preset/replace function by the count disable/preset/replace function
5
Performing the preset/replace function by the latch counter/preset/replace function
All the above preset/replace functions cannot be performed while CH External preset/replace (Z Phase) request detection
(RX23, RX3B) is on.
122
Method
Reference
Page 123, Section 8.4 (1)
Page 124, Section 8.4 (2)
Page 114, Section 8.3.3
Page 142, Section 8.11
Page 145, Section 8.12