8. Light processor assembly
8.7
Installation of the light processor assembly
Necessary tools
•
Flat screw driver 8 x 150
•
Allen wrench 4 mm
How to install
1. Make sure there is no lens mounted.
2. Check if the corner bracket is mounted on the new assembly. If not yet mounted, remove the corner bracket of the removed
assembly and mount it on the new one.
Image 8-10
Corner bracket light processor assembly
3. Take the light processor assembly by its handles and gently slide in the assembly into the compartment of the projector.
Make sure that the positioning pins (P) at the backside of the assembly match the positioning holes (H) in the projector.
Note: While inserting the assembly, guide the cables to the back plane side.
144
R5905043 DP2K-12C/11CX 19/02/2018