Installation Of The Lps Module - Barco DP2K-12C Service Manual

17.4 Installation of the LPS module

Necessary tools
• 6 x 120 mm flat screwdriver.
• Torque wrench with a 10 mm hexagon socket.
How to install the LPS module
1. Slide the LPS module into its compartment as illustrated.
Image 17-9
Insert LPS module
2. Fasten the four captive screws of the LPS module.
Image 17-10
Fixate LPS module
3. Connect the power cables coming from the SPG module with the "LAMP OUT" sockets of the LPS module as illustrated. Fasten
the nuts with a torque of 4Nm (2.95 lbf*ft).
Warning: Make sure to place the washers and cable eye in correct order upon the pin as illustrated. Always use a plain washer
between the output pin and the cable eye.
Image 17-11
Lamp out connection
P LPS output pin.
W Plain washer.
L Lock washer.
E1 Cable eye from SPG module.
E2 Cable eye from LPS unit.
N Nut.
Warning: Respect the polarity of the socket and cables. Red marked cables with the "+" pin, black marked cables with the "-"
pin.
R5905043 DP2K-12C/11CX 19/02/2018
P
W
E1
17. Lamp power supply
W
L
N
289