Barco DP2K-12C Service Manual page 240

12. Card Cage
Image 12-45
Projector ID card removal
Mounting new signal backplane
1. Open the Projector Id card holder by pushing it a few millimeters to the left and turn it over.
Insert the Projector ID card with the chip upwards.
Turn the holder back, push it a little bit down while sliding it to the right until it locks.
Image 12-46
Projector ID card, installation
2. Take the new backplane and slight the right side under an angle through the gap in the side of the card cage.
Pivot the backplane on its place.
236 R5905043 DP2K-12C/11CX 19/02/2018