Barco DP2K-12C Service Manual page 329

2
Image 20-22
Remove fan assembly
4. Remove the fan from the fan house by releasing first the 11 small screws at the edge (reference 3) and then the 4 big screws in
the middle (reference 4) as illustrated. Use a 2,5 mm and a 3 mm Allen wrench.
Image 20-23
Remove fan
5. Install a new anode fan inside the fan house as follows:
a) Guide the wire unit of the anode fan through the holes in mounting plates.
b) Fasten the two mounting plates upon the fan with four hexagon socket head cap screws (reference 6) as illustrated. Provide
each screw with a washer (reference 7).
c) Close the anode fan house with 11 screws (reference 8).
6
7
Image 20-24
Mount fan
6. Slide the anode fan assembly back in its compartment and secure with 3 big hexagon screws (reference 9). Use a 5 mm Allen
wrench.
R5905043 DP2K-12C/11CX 19/02/2018
3
8
20. Fan replacement procedure
2
4
5
325