Barco DP2K-12C Service Manual page 103

Image 6-7
3. Release the four retaining thumbscrews of the UV blocker assembly as illustrated. Make sure that the UV blocker assembly
remains in its position while releasing the screws.
Image 6-8
4. Support the xenon lamp inside the Lamp House with one hand while removing the UV blocker assembly from the Lamp House.
Note that some xenon lamps are installed with an anode adaptation bushing.
Caution: Ensure that you wear protective clothing, a full face shield and protective gloves.
Image 6-9
5. Slide the white anode socket, which is connected via a thick wire with the xenon lamp, upwards away from its position and then
remove the xenon lamp with anode socket from the Lamp House.
R5905043 DP2K-12C/11CX 19/02/2018
6. Lamps and lamp houses
99