Barco DP2K-12C Service Manual page 109

Image 6-18
Anode socket installation
7. Reinstall the UV blocker assembly as illustrated. Make sure that the xenon lamp is properly supported by the lamp supporting
mechanism in the centre of the UV blocker. Use the opening at the side of the Lamp House to guide the supporting pin of the
xenon lamp into the anode supporting mechanism.
Image 6-19
UV blocker installation
8. Secure the UV blocker by fastening the four retaining thumbscrews as illustrated.
Note: Please ensure that the thumb screws turning wires are flush with the cover or interference will occur while inserting the
lamp house into the projector.
Image 6-20
Secure UV blocker
9. Fasten the cathode side of the xenon lamp using a hexagon socket head screw M6 x 40 and a plain washer as illustrated. Use a
torque of 2,5 Nm (1,84 lbf*ft) to fasten the hexagon socket head screw. Use for that a torque wrench with a 5 mm Allen socket.
Caution: Make sure that the both pins of the cathode adapter remain engaged in the foreseen slots. Use one hand to keep
the xenon lamp into position while inserting the hexagon socket head screw.
R5905043 DP2K-12C/11CX 19/02/2018
6. Lamps and lamp houses
105