Barco DP2K-12C Service Manual page 70

4. Troubleshooting
Code 5816: "ti-icp - key error" (Error)
Situation
New ICP software version installed
but no reboot of projector has
happen.
Error remains occurring after
different boot cycles.
Code 5817: "ti-icp - icp board not detected" (Error)
Situation
There is no ICP board installed.
ICP board not correctly inserted.
Code 5830: "ti-link-decryptor - no communication" (Error)
Situation
Link decryptor is not correctly seated.
Code 5831: "ti-link-decryptor - system error" (Error)
With the Communicator, go to Diagnostics → Actual → Link Decryptor status → Error messages
The following errors can occur:
Error
Link decryptor - User loader integrity
error
Link decryptor - Main application
integrity error
Link decryptor - RNG hardware
integrity error
Link decryptor - DRNG hardware
integrity error
Link decryptor - RSA algorithm
integrity error
Link decryptor - AES algorithm
integrity error
Link decryptor - HMAC algorithm
integrity error
Link decryptor - SHA algorithm
integrity error
Link decryptor - TLS integrity error
Link decryptor - FPGA configuration
integrity error
Link decryptor - FPGA cinelink 2
decryption integrity error
Link decryptor - Real time clock error
Link decryptor - FPGA configuration
error
Link decryptor - FPGA temperature
out of range
Link decryptor - RNG Hardware
duplicate output error
Link decryptor - DRNG Hardware
duplicate output error
66
Solution
Reboot projector
Replace ICP board. See "Removing a board in the card cage", page 213.
Solution
Install an ICP board.
Re-install the ICP board.
Solution
Reseat the link decryptor.
If problem remains, replace the link decryptor.
Solution
Replace link decryptor. See "Replacement of the Link Decryptor", page 243.
Replace link decryptor. See "Replacement of the Link Decryptor", page 243.
Replace link decryptor. See "Replacement of the Link Decryptor", page 243.
Replace link decryptor. See "Replacement of the Link Decryptor", page 243.
Replace link decryptor. See "Replacement of the Link Decryptor", page 243.
Replace link decryptor. See "Replacement of the Link Decryptor", page 243.
Replace link decryptor. See "Replacement of the Link Decryptor", page 243.
Replace link decryptor. See "Replacement of the Link Decryptor", page 243.
Replace link decryptor. See "Replacement of the Link Decryptor", page 243.
Replace link decryptor. See "Replacement of the Link Decryptor", page 243.
Replace link decryptor. See "Replacement of the Link Decryptor", page 243.
Replace link decryptor. See "Replacement of the Link Decryptor", page 243.
Replace link decryptor. See "Replacement of the Link Decryptor", page 243.
Temperature on the link decryptor is to high. Check for other fan or temperature error
messages. Check if the front cover of the HDSDI module is closed.
Replace link decryptor. See "Replacement of the Link Decryptor", page 243.
Replace link decryptor. See "Replacement of the Link Decryptor", page 243.
R5905043 DP2K-12C/11CX 19/02/2018