Lamp Info Module Fan - Barco DP2K-12C Service Manual

20.7 Lamp Info Module fan

To access the Lamp Info Module fan the lamp cover has to be removed. This procedure assumes that the lamp
cover is already removed.
Necessary tools
3 mm Allen wrench.
How to replace the fan of the Lamp Info module?
1. Disconnect the wire unit (reference C) of the fan (reference FL).
FL
Image 20-31
2. Remove the fan from the projector by releasing the two hexagon socket head cap screws (reference 1). Use a 3 mm Allen
wrench.
Image 20-32
3. Install a new fan as illustrated in image 20-32. Use a 3 mm Allen wrench to fasten the two hexagon socket head cap screws.
4. Reconnect the wire unit of the fan.
R5905043 DP2K-12C/11CX 19/02/2018
20. Fan replacement procedure
C
1
329