Installation Of A New Integrator Rod - Barco DP2K-12C Service Manual

10.4 Installation of a new integrator rod

C
AUTION
rod will burn into the rod and cause permanent damage.
How to install
1. Unpack the new integrator rod very carefully.
Be careful not to damage the integrator rod.
2. From the left, slide the integrator rod into the opening in the cooling block (1) Do not touch the entrance of the integration rod to
any mechanical part of the cooling block. That can damage the rod severely with a bad image as result.
Image 10-7
Mount integration rod
3. Slide it in so that the front of the other side of the integrator rod is equal with entrance of the rod holder (2)
Again, do not slide in the integrator rod too far to avoid damage to the entrance of the rod.
4. Place the integrator rod cover plate on its place (1) and secure with the 4 screws (2).
R5905043 DP2K-12C/11CX 19/02/2018
:
Use cotton gloves to handle the integrator rod. Greasy fingerprints or other dirt on the integrator
1
2
10. Integrator rod
173