Barco DP2K-12C Service Manual page 182

10. Integrator rod
6. Turn the lower nut of the folding mirror until the upper and left edge of the rod can be seen on the screen.
7. Gently rotate ring 2 back or forward to a position which projects the sharpest possible edges on the screen.
Image 10-13
8. Gently move the handle 3 back or forward to a position so that the projected light beam matches the projected outline of the
DMD's
Note: No spots in the projected image may move along with the movements of the rod. Spots which move with the movements
of the rod indicates that the exit side of the integrator rod is contaminated with dust. If this is the case, remove the
integrator rod and try to blow away the dust. If this doesn't help replace the integration rod.
Image 10-14
9. Fasten the lock nut (1) with a torque of 2 Nm.
10.Turn the lower nut of the folding mirror back to its original position (see alignment procedure of the folding mirror for the correct
alignment)
11. Mount the Fold Mirror cover and the Light Sensor Module.
178
2
3
R5905043 DP2K-12C/11CX 19/02/2018