16. Removal and installation of the projector covers
16.7 Installation of the light unit cover
W
ARNING
Necessary tools
7 mm flat screw driver.
How to install the light unit cover
1. Install the light unit cover of the projector as follows:
a) Bring the light unit cover towards its final position (A),
b) then gently push the locking stud at the left top corner (B) into its receiver,
c) then gently push the locking stud at the left bottom corner (C) into its receiver.
A
Image 16-14
Light unit cover installation
2. Secure the light unit cover by locking the two captive screws at the right side of the light unit cover.
Image 16-15
Captive screw locking
398
:
This procedure may only be performed by qualified technical service personnel.
B
C
R5905158 HDF SERIES 08/12/2016