Installation Of The - Barco DP2K-12C Service Manual

5. Removal and installation of projector covers
5.12 Installation of the front cover
The input cover and the lens may not be installed yet.
Necessary tools
Flat screw driver.
How to install the front cover of the projector?
1. Check if the front filter is present.
2. Ensure that no lens is mounted and that the input cover is not installed.
3. Install the front cover of the projector doing the following:
a) first hook in the side of the front cover at the front filter,
b) then gently push the other side of the front cover into position,
c) ensure that the locking studs in the corners click into their receivers.
Image 5-23
Install front cover
4. Secure the front cover by locking the captive screw in the middle at the bottom of the front cover.
Image 5-24
Fasten front cover
5. Reinstall the rubber dust ring around the lens holder. See detail at the right of image 5-24.
90
A
R5905043 DP2K-12C/11CX 19/02/2018
B
C