Barco DP2K-12C Service Manual page 69

Image 4-41
Code 5814: "ti-icp - self test = fail" (Error)
Situation
A wire unit to one of the formatters
is not correctly connected to the
Signal backplane (reference 1, 2, 3
for green on image 4-39).
A wire unit on one of the formatters
is not correctly connected (reference
4, 5, 6 for red on image 4-39).
Code 5815: "ti-icp - certificate error" (Error)
Situation
New ICP software version installed
but no reboot of projector has
happen.
Error remains occurring after
different boot cycles.
R5905043 DP2K-12C/11CX 19/02/2018
Solution
Check the connections between the formatters and the Signal backplane on the Signal
backplane side.
The TI log file will indicate which formatter connection has failed
If problem remains, replace ICP board. See "Removing a board in the card cage",
page 213.
Check the connections between the formatters and the Signal backplane on the
formatter side.
If problem remains, replace ICP board. See "Removing a board in the card cage",
page 213.
Solution
Reboot projector
Replace ICP board. See "Removing a board in the card cage", page 213.
4. Troubleshooting
65