Barco DP2K-12C Service Manual page 77

Image 4-44
ICP fan connection
Code 6131: "icp fan - voltage high" (Warning)
Situation
Malfunction Fan Control board or
SMPS board.
Code 6133: "icp fan - voltage low" (Warning)
Situation
Malfunction Fan Control board or
SMPS board.
Short circuit or bad connection.
Damaged insulation of the wire
unit of the fan (reference 1 & 2
image 4-44) Note that this fan is
in the Card Cage compartment
underneath the Fan & Motor Control
board.
Code 6200: "maintenance - maintenance required" (Notification)
Situation
Projector requires maintenance.
Code 6210: "lens - no lens parameter file has been activated" (Warning)
Situation
No lens parameter file has been
activated.
R5905043 DP2K-12C/11CX 19/02/2018
1
Solution
Measure on the Signal Backplane the ++12V voltage on pin 1, 2 or 3 of the connector of
the black wire unit which comes from the SMPS board. See image 4-43.
If the measured voltage is about12V then replace the Fan Control board. See
"Removing a board in the card cage", page 213. Otherwise replace the SMPS board.
See"Replacement of the Switched Mode Power Supply", page 281.
Solution
Measure on the Signal Backplane the ++12V voltage on pin 1, 2 or 3 of the connector of
the black wire unit which comes from the SMPS board. See image 4-43.
If the measured voltage is about12V then replace the Fan Control board. See
"Removing a board in the card cage", page 213. Otherwise replace the SMPS board.
See"Replacement of the Switched Mode Power Supply", page 281.
Check the Signal Backplane for bad connections.
Check the insulation of the wire unit of the fan.
1. Repair the insulation of the wire unit using shrink sleeve.
2. If not repairable, replace the whole wire unit and/or fan. See "Integrated cinema
processor fan", page 330.
Solution
Go to the menu "Maintenance → Smart maintenance" in the Communicator
software.
See also maintenance program of the projector (included in the service manual).
Solution
Select a suitable lens parameter file for the installed lens using the Communicator
software.
>Installation >Advanced >Lens parameters >Select
4. Troubleshooting
2
73