Integrated Cinema Processor Fan - Barco DP2K-12C Service Manual

20. Fan replacement procedure

20.8 Integrated cinema processor fan

Preparations
First remove the following parts to get access to the fan.
1. Input cover and top cover, see Removal and Installation of the projector covers.
2. Remove the fan controller board, see "Removing a board in the card cage", page 213.
3. Remove the button unit, see "Removing the button unit", page 219.
How to replace
1. Disconnect the fan power cable from the backplane.
Image 20-33
Fan connection
2. To work handy it is recommended to slide out the intermediary plate a little bit. To it as follow:
a) cut the necessary wire ties.
b) turning out both fixation screws.
c) sliding the plate backwards.
Image 20-34
Fan removal
3. Slide the cable through the hole in the intermediary plate.
4. Turn out the 4 fixation screws (reference 1).
5. Take off the fan.
6. Mount a new fan with the arrow indication pointing to the plate and drive in the 4 fixation screws.
7. Push the power cable through the hole in the plate.
8. Slide the intermediary plate back on its place and drive in both fixation screws.
9. Connect the power cable to the backplane. Secure the wires units with a few wire ties.
330
1
R5905043 DP2K-12C/11CX 19/02/2018