Barco DP2K-12C Service Manual page 124

6. Lamps and lamp houses
Image 6-44
7. Place a new reflector assembly upon the anode side of the lamp house and fasten with 8 hexagon head cap screws (reference
7 image 6-44). Use a 2,5 mm Allen wrench. These screws must have a length of 10 mm. Make sure to position the reflector
assembly correctly.
Caution: Do not touch the glass of the reflector assembly. Hold fast the reflector assembly by its metal mounting plate.
8. Reinstall the cathode side of the lamp house (see middle drawing of image 6-44). Fasten with 8 hexagon head cap screws
(reference 6 image 6-44). Use a 2,5 mm Allen wrench.
9. Reinstall the bottom profiles. See image 6-43. Use a 2,5 mm Allen wrench.
10.Guide the cathode wire inside the lamp house as illustrated.
Image 6-45
11. Reconnect the cathode wire with the lamp house. Make sure to place a washer (reference 2 and 4 ) between the nuts and the
eye of the cathode wire (reference 3). Use a torque of 9 Nm to fasten the nuts (reference 1 and 5). Block the first nut (reference
1) with a 17 mm open-end wrench while applying a torque of 9 Nm on the second nut (reference 5) with a torque wrench.
1
Image 6-46
12.Reinstall the side cover of the lamp house.
120
6
2 3 4 5
7
9 Nm 9 Nm
R5905043 DP2K-12C/11CX 19/02/2018