Lamp Cathode Fan - Barco DP2K-12C Service Manual

20.4 Lamp cathode fan

To access the cathode fan, the lamp house has to be removed. This procedure assumes that the lamp cover
and lamp house are already removed.
Preparations
1. Remove the lamp cover.
2. Remove the lamp house.
Necessary tools
• 3 mm Allen wrench.
• 7 mm flat screwdriver.
• 7 mm nut driver.
How to replace
1. Remove the left side panel of the lamp compartment by removing the six indicated screws (reference 1).
1
1
1
Image 20-10
Side panel lamp house, removal
2. Pull out the wire unit with connector from behind the plate and disconnect the power cable of the cathode fan.
R5905043 DP2K-12C/11CX 19/02/2018
20. Fan replacement procedure
319