Lamps And Lamp Houses - Barco DP2K-12C Service Manual

6. LAMPS AND LAMP HOUSES

About this chapter
This chapter enumerates all the supported xenon lamps for the DP2K-12C/11CX and how to replace the xenon lamp in the lamp
house. Also included is the procedure to reset the lamp parameters, which is required after a xenon lamp replacement, and the
procedure to realign the lamp in its reflector for optimal performance.
W
ARNING
XENON LAMP HANDLING OR SERVICE. ONLY TRAINED AND QUALIFIED TECHNICAL SERVICE PERSONNEL
ARE ALLOWED TO HANDLE THE XENON LAMP.
C
AUTION
of the bulb increases the pressure to a level at which the bulb may explode if not handled in strict accordance
to the manufacturer's instructions. The bulb is stable at room temperature, but may still explode if dropped or
otherwise mishandled. Whenever the lamp house, containing a xenon lamp, has to be dismantled or whenever
the protective container or cloth has to be removed from the xenon lamp, authorized protective clothing MUST
be worn!
W
ARNING
W
ARNING
W
ARNING
Overview
• Introduction
• Removal of the lamp house
• Removal of the xenon lamp
• Installation of the Xenon lamp
• Installation of the lamp house
• Resetting the lamp parameters
• Realignment of the lamp in its reflector
• Replacement of the Lamp Info module
• Replacement of the UV blocker
• Replacement of the lamp reflector
• Cleaning the Reflector of the Lamp House
• Cleaning the UV blocker of the Lamp House
R5905043 DP2K-12C/11CX 19/02/2018
:
DO NOT PERMIT UNAUTHORIZED PERSONNEL TO PERFORM OR ATTEMPT ANY PHASE OF
:
Xenon compact arc lamps are highly pressurized. When ignited, the normal operating temperature
:
Always wear face protection (full face shield) when handling xenon lamps.
:
Always wear protective clothing (welder's jacket) when handling xenon lamps.
:
Always wear clean leather gloves with wrist protectors when handling xenon lamps.
6. Lamps and lamp houses
93