17.3 Removal of the LPS module
Necessary tools
•
6 x 120 mm flat screw driver.
•
10 mm nut driver.
How to remove the LPS module
1. Remove the back cover of the projector.
2. Disconnect the "MAINS INPUT" from the LPS units.
Image 17-4
Mains input
3. Disconnect the wire unit from the "CTRL IN" socket of LPS unit.
Image 17-5
CTRL in connector
4. Disconnect both "LAMP OUT" power cables from the LPS module. Use a 10 mm nut driver.
Caution:
Do not loose the washers which fit between the fixation nuts and the cable eye.
Tip:
Place the washers and nuts back upon the output pins.
R5905043 DP2K-12C/11CX 19/02/2018
17. Lamp power supply
287