Icp Software Upgrade - Barco DP2K-12C Service Manual

13.3 ICP software upgrade

About updating ICP board
The ICP board contains 2 slots to store software before this software can be installed. Therefore it is recommended to store the
previous version of the software in a location and the current version in the other. When an new update becomes available, overwrite
always the oldest version.
These 2 loaded versions make it possible to switch on an easy way between the current version and the previous one.
How to upgrade
1. Launch the DC Update Companion as described in "Software upgrade, launch DC update companion", page 248.
2. Select package type. Click on the drop down box (1) and select ICP Package .
Image 13-8
3. Browse the package file name. Click on Browse (2) to open the Browser window (3).
Note: File has extension release.
The correct file type is already filled out (4).
4. Browse for the desired file (5), select the file and click on Open (6).
The Package file name line is filled out (7).
5. Enter the device IP address (10) or click on Browse to open a device selection window (11).
Note: The IP of the connected projector is already filled out. When using the DC Update Companion as stand alone program,
then this field is blank.
R5905043 DP2K-12C/11CX 19/02/2018
13. Software update via Communicator (DC update companion)
255