Removal And Installation Of Projector Covers - Barco DP2K-12C Service Manual

5. REMOVAL AND INSTALLATION OF PROJECTOR
COVERS
About this chapter
Most maintenance and servicing procedures demand removing one or more of the projector covers to gain access to the parts to
maintain or to service. To avoid redundancy, all procedures about cover removing or installing are grouped together in this chapter.
The maintenance and servicing procedures also refer to this chapter if required. The procedures in this chapter describe, with
detailed step by step actions and illustrations, how to remove or install the projector covers. Note that some covers may only be
removed by qualified service personnel, see remarks above each procedure.
W
ARNING
unless otherwise stated.
Overview
• Removal of the lamp cover
• Removal of the input cover
• Removal of the front cover
• Removal of the side cover
• Removal of the rear cover
• Removal of the top cover
• Open the sealed compartment
• Close the sealed compartment
• Installation of the top cover
• Installation of the rear cover
• Installation of the side cover
• Installation of the front cover
• Installation of the input cover
R5905043 DP2K-12C/11CX 19/02/2018
:
Always switch off the projector and unplug the power cord before removing one of the covers,

5. Removal and installation of projector covers

77