Barco DP2K-12C Service Manual page 301

Image 18-7
Fixation frame
4. Secure the 4 spring screws (1).
1
Image 18-8
Fixation screws and power connection
5. Connect the grounding wire (PE wire) mounted on the LPS fixation into the socket of the LPS unit (2, image 18-8.
6. Connect the mains input cables with the MAINS INPUT sockets of each LPS module as illustrated (3, image 18-8).
7. Connect the power cables coming from the SPG module with the LAMP OUT sockets of the LPS module as illustrated. Fasten
the nuts with a torque of 4Nm (2.95 lbf*ft).
Warning: Make sure to place the washers and cable eyes in correct order upon the pin as illustrated. Always use a plain
washer between the output pin and the cable eyes.
Image 18-9
Lamp out connection
P LPS output pin.
W Plain washer.
L Lock washer.
R5905043 DP2K-12C/11CX 19/02/2018
3
1
2
W
18. Lamp power supply (single module)
P
E1
W
L
N
297