Removal Of The Lamp Cover - Barco DP2K-12C Service Manual

5. Removal and installation of projector covers
5.1

Removal of the lamp cover

W
ARNING
Necessary tools
Flat screw driver.
How to remove the lamp cover of the projector?
1. Release the two captive screws at the right side, top and bottom, of the lamp cover, using a flat screw driver.
Image 5-1
Release lamp cover
2. Remove the lamp cover from the projector doing the following:
a) gently pull out the left bottom corner (A) of the lamp cover,
b) then gently pull out the left top corner (B) of the lamp cover,
c) then move the lamp cover away from the projector (C).
B
A
Image 5-2
Remove lamp cover
78
:
This procedure may only be performed by qualified technical service personnel.
C
R5905043 DP2K-12C/11CX 19/02/2018