Image 11-27
4. Reinstall the stepper motor on the assembly as illustrated in image 11-26. Fasten the four screws (reference 9) with a 3mm Allen
wrench.
5. Reinstall the front plate from the Lens Holder. Use a 13mm open end wrench to fasten the four big nuts (reference 7 image 11-25).
Fasten the big nuts crosswise bit by bit. Ensure that the upper two rods and the lower left rod contain a big spring.
Proceed with reinstalling the Lens Holder. See procedure "Install the lens holder", page 189.
The Lens Holder has to be adjusted after installation. See procedure "Scheimpflug adjustment", page 192.
R5905043 DP2K-12C/11CX 19/02/2018
11
10
11. Lenses and Lens holder
197