Lens Installation - Barco DP2K-12C Service Manual

11.4 Lens installation

How to install a lens into the projector lens holder ?
1. Remove the foam rubber in the opening of the lens holder if not removed yet.
2. Take the lens assembly out of its packing material and remove the lens caps on both sides.
3. Close the lens locking mechanism prior to lens insertion (1). Lens locking mechanism is closed by pushing the lens lock to the
right.
3
2
Image 11-9
1 Lens holder lock
2 Power connector lens
3 Alignment pin
4. Ensure that the lens holder stands in the On-Axis position (horizontal and vertical mid position).
Note: The lens holder is placed default in the On-Axis position at factory.
5. Gently insert the lens in such a way that the lens connector matches the socket (B).
Image 11-10
6. Insert the lens until the connector seats into the socket.
Warning: Do not release the Lens yet, as the Lens may fall out of the Lens Holder.
A clear "click" should be heard when the retainer springs engage into the slot provided on the lens. Besides the clear click, the
springs actually help to guide the lens into position and hence prevent jamming.
7. Check if the lens is really secured by trying to pull the lens out of the lens holder.
R5905043 DP2K-12C/11CX 19/02/2018
1
11. Lenses and Lens holder
183