Battery Replacement On The Cinema Controller Board - Barco DP2K-12C Service Manual

12.8 Battery replacement on the Cinema Controller Board

About an empty battery
There is no error indication in Communicator when the battery is almost empty. Only when opening the error logging after powering
on the projector, you will see that some time stamps in the beginning of the list are missing or that these time stamps are still old
timings. That is due to an empty battery on the Cinema Controller Board.
There is no battery kit available. The customer has to buy a new battery himself.
Battery type used : CR1220 (3V, 0.03AH, Li)
Necessary tools
PH2 Phillips screwdriver.
Necessary parts
Battery CR1220
How to replace
1. Loosen the two screws (reference 1) at the front of the Cinema Controller.
2. Pull the Cinema Controller out of its compartment.
3. Pull out the empty battery and insert a new CR1220 battery with the flat side of the battery facing to the top.
Note: No battery kit available as spare part. Buy a new one in a dedicated shop.
Image 12-10
Battery replacement
4. Gently insert the Cinema Controller in the guides of the Cinema Controller compartment as illustrated. Push it completely in.
Caution: Ensure that the both sides of the Cinema Controller are captured by the guides inside the Cinema Controller com-
partment, as shown in the detail of the illustration.
5. Fasten the two screws at the front side of the Cinema Controller (reference 1).
R5905043 DP2K-12C/11CX 19/02/2018
12. Card Cage
217