Barco DP2K-12C Service Manual page 67

1
Image 4-38
Light processor cover tamper switches
Code 5807: "ti-icp - read system status failed" (Error)
The Barco controller can not read the status of the ICP.
Situation
ICP board is not correctly inserted
ICP crash. The most left LED is not
blinking
ICP is being upgrading
Code 5812: "ti-icp - read satellite info failed" (Error)
Situation
A wire unit to one of the formatters
is not correctly connected to the
Signal backplane (reference 1, 2, 3
for green on image 4-39).
A wire unit on one of the formatters
is not correctly connected (reference
4, 5, 6 for red on image 4-39)
Image 4-39
Formatter connections
Code 5813: "ti-icp - satellite firmware mismatch" (Error)
This error can occur when you move ICP boards between projectors which have a different DMD configuration. (E.g. switching an
ICP between a 1.2 and 0.98 inch system)
R5905043 DP2K-12C/11CX 19/02/2018
Solution
Insert the ICP board properly.
Restart the projector.
Wait until projector reset after the upgrade.
Solution
Check the connections between the formatters and the Signal backplane on the Signal
backplane side.
Check the connections between the formatters and the Signal backplane on the
formatter side.
1
2
3
4. Troubleshooting
2
5
6
4
63