16.2 Replacement of the Switched Mode Power Supply
Necessary tools
•
7 mm nut driver or
•
flat screw driver
How to replace
1. Release the 4 spring locks (1).
Image 16-1
SMPS cover
2. Take off the cover.
3. Disconnect the following connectors:
-
Mains input (1)
-
Ground wire (2)
-
Control connector (blue wires) (3)
-
Power out connector (black wires) (4)
1
2
Image 16-2
SMPS connections
4. Slide out the Switched Mode Power Supply board.
Image 16-3
5. Take a new unit and inset the board in the guides.
Pull it completely in.
R5905043 DP2K-12C/11CX 19/02/2018
1
3
4
16. Switched mode power supply
281