Introduction - Barco DP2K-12C Service Manual

15. Power input

15.1 Introduction

Power Input
The power input of the projector is located at the rear side of the projector. The electrical connection with the local power net is fixed
wired. The local power net is connected with a built-in 3-terminal strip. The power is applied to the mains filter via the mains switch.
Two power cables are connected with the output side (LOAD) of the mains filter. One cable leads via the 5,5 ampere protected C13
power output socket and a C14 power input socket to the SMPS and is used to provide the electronics of the projector with power.
The other cable goes to the Lamp Power Supply module. By default the power output and input socket are connected with a short
power cable. When an Uninterrupted Power Supply (UPS) is required, the short cable is removed and the UPS is connected to the
power input C14 socket.
Power Input parts location
1
3
Image 15-1
Power input
1 Terminator block.
2 Automatic circuit breaker with ON/OFF switch.
3 Mains input filter.
4 Power input C14 socket for projector electronics (UPS purpose).
5 Protected power output C13 socket.
6 Adjustable brackets for securing the power plugs.
7 Loop through power cable.
268
2
4
5
6 7
R5905043 DP2K-12C/11CX 19/02/2018