Replacement Of The Mains Input Filter - Barco DP2K-12C Service Manual

15.4 Replacement of the mains input filter
This procedure assumes that the Mains Input components are accessible.
Necessary tools
• 3 mm Allen wrench.
• 10 mm open-end wrench.
How to replace the mains input filter
1. Remove both nuts on the "LOAD" side (reference A and B of image 15-8) of the mains input filter and slide off all eye connections.
Do not drop the lock washers in the projector. Use a 10 mm open-end wrench.
2. Remove both nuts on the "LINE" side (reference C and D of image 15-8) of the mains input filter and slide off all eye connections.
Do not drop the lock washers in the projector. Use a 10 mm open-end wrench.
Image 15-8
LOAD connections
3. Remove the mains input filter by releasing the four hexagon socket head cap screws as illustrated. Use a 3 mm Allen wrench.
Image 15-9
Mains input filter removal
4. Place a new mains input filter on its position and fasten with four hexagon socket head cap screws. Make sure that the "LOAD"
side is facing downwards. Use a 3 mm Allen wrench.
5. Connect the wires with the same colors of the LPS cables and the wire from the mains output with the "LOAD" side of the mains
input filter (reference A and B of image 15-8). First slide the eye connections of the wires over the pin (same colors together),
then slide a washer followed by a lock washer over the pin and secure with a nut. Use a 10 mm open-end wrench.
R5905043 DP2K-12C/11CX 19/02/2018
A B
15. Power input
C D
273