Replacement Of The Link Decryptor - Barco DP2K-12C Service Manual

12.15 Replacement of the Link Decryptor

Location
The link decryptor is mounted on the HD-SDI board.
Necessary tools
Torx screwdriver T10
How to replace
1. Remove the HD-SDI board in the card cage. See "Removing a board in the card cage", page 213.
2. Turn out the 4 fixation screws.
1
2
Image 12-60
Link decryptor fixation
3. Pull off the current mounted link decryptor board.
4. Unpack the new link decryptor board and plug it in both connectors at the same time (black and white connector on the link
decryptor must facing the board connectors of the HD-SDI board..
2
Image 12-61
Link decryptor, mounting
5. Drive in the 4 fixation screws.
6. Re-install the board in the card cage.
When inserting a new Link decryptor, the link decryptor software must be re-installed. See "Software update
via Communicator (DC update companion)", page 247.
R5905043 DP2K-12C/11CX 19/02/2018
4
3
1
12. Card Cage
243