10. Integrator rod
10.3 Removal of the integrator rod
To remove the integrator rod from the light pipe the light processor unit has to be removed from the projector
first.
C
AUTION
blow away all dust on the outside of the Light Processor unit before entering the unit into the dust free area.
Necessary tools
•
Allen wrench 2.5 mm
•
Allen wrench 3 mm
How to remove
1. Disconnect the cable of the light sensor unit.
2. Turn out both screws ( reference 1) and slide out the eye plate.
Note: Light processor may be placed on the pins and the top of the processor mechanics. without damaging any part inside
the assembly.
Image 10-3
3. Turn out the screws of the light pipe housing (4 times 2 screws)
170
:
All servicing to the Light Processor unit has to be done in a dust free area. Use compressed air to
1
R5905043 DP2K-12C/11CX 19/02/2018