Barco DP2K-12C Service Manual page 209

3
Image 11-38
3. Use a 5.5 mm nut driver to loosen the six nuts on the dust rubber (reference 5 image 11-39). Remove the nuts, the inner dust
rubber frame (reference 6) and the old rubber (reference 7).
6
5
Image 11-39
4. Place the new inner dust rubber (reference 7 image 11-39) over the pins of the new cover. Carefully place the new dust rubber
frame (reference 6) of the dust seal over the top of the rubber and over the pins of the new cover. Then use a 5.5 mm nut driver
to tighten the dust rubber and dust rubber frame with the six nuts (reference 5).
5. Install the new Lens Holder Cover. Use a PH1 Phillips screwdriver to tighten the seven original screws (reference 3 image 11-38).
Make sure you tighten the earth wire (reference 4) back to its original place. Be careful as not to damage the rubber while doing
these actions.
6. Carefully reinstall the front plate onto the Lens Holder. Help the rubber through the Lens Holder onto the other side.
R5905043 DP2K-12C/11CX 19/02/2018
4
7
11. Lenses and Lens holder
205