Getting Access To The Mains Input Components - Barco DP2K-12C Service Manual

15.2 Getting access to the Mains Input components

This procedure explains how to disconnect the power cord and how to remove the terminator block in order
to get access to the mains filter and mains ON/OFF switch. This procedure assumes that the rear cover and
lamp cover of the projector are already removed.
Necessary tools
• 3 mm Allen wrench.
• Flat blade screw driver.
• Torx screw driver T20
How to get access to the Mains Input components?
1. Make sure that the power cord of the projector is powerless.
2. Remove the cover of the AC compartment by releasing the three captive dumb screws.
Image 15-2
AC power compartment cover
3. Disconnect the AC power cord from the 3–terminal strip and guide the AC power cord out of the compartment.
4. Remove the cover plate by releasing the 3 hexagon socket head cap screws and the 2 Torx screws as illustrated.
Image 15-3
Mains input cover
R5905043 DP2K-12C/11CX 19/02/2018
15. Power input
269