Replacing A Large Frame Lps With A Single Module Lps - Barco DP2K-12C Service Manual

18.4 Replacing a large frame LPS with a single module LPS

How to replace
1. Remove the large frame LPS module, "Removal of the LPS module", page 287.
2. Before inserting an LPS unit, place the positioning pin at the backside in its correct position.
A
Image 18-12
Positioning pin
A To be built-in in the left position (for DP2K-12C)
B To be built-in in the right position
For a LPS unit to be built-in at the left side of the LPS compartment (DP2K-12C), the positioning pin must be in the left position
when seen from the backside of the unit.
To move the pin to the left or the right, pull on the pin and slide it to the left or to the right.
3. Slide a single LPS units n the compartment at the left side.
Image 18-13
Insert LPS unit
4. Slide the fixation frame on the front of the LPS unit in such a way that the fixation pins match the fixation holes.
R5905043 DP2K-12C/11CX 19/02/2018
18. Lamp power supply (single module)
B
299