Barco DP2K-12C Service Manual page 324

20. Fan replacement procedure
Image 20-11
Cathode fan, power disconnection
3. Remove the small side plate of the air channel by releasing the three screws (reference 2). Cut the foam rubber (reference 3)
as it is stuck on different plates.
2
Image 20-12
Small side plate, removal
4. Remove the cathode fan assembly out of its compartment by releasing the five indicated screws (reference 4). Cut the foam
rubber (reference 5) as it is stuck on different plates.
Tip: Lift up and slightly turn the fan assembly to remove.
4
Image 20-13
Cathode fan assembly removal
5. Disassemble the cathode fan assembly by removing the five indicated screws (reference 6).
320
3
5
4
R5905043 DP2K-12C/11CX 19/02/2018